Advice sought for holes close on Mini DisplayPort

Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic

I have a sticky issue for a Mini DisplayPort connector with through hole pins.

The holes are recommended at 0.6mm but there are holes only 1mm apart!

So, in order to maintain a clearance of say 0.15mm between pads I get 0.85mm diameter pad (compared to recommended pad of 1.1mm for 0.6mm hole).

So, the question is, which 'rules' are best to follow.

I am inclined towards maintaining the pad to pad spacing and having a tight annular ring, rather than compromise pad to pad spacing for a larger ring and risk bridging.

Any guidance on this appreciated.

Cheers!

Author	Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic
DaveCowl Members Profile Send Private Message Find Members Posts Add to Buddy List Advanced User Joined: 18 Oct 2012 Location: Santa Clara, CA Status: Offline Points: 161	Post Options Post Reply Quote DaveCowl Report Post Thanks(0) Quote Reply Topic: Advice sought for holes close on Mini DisplayPort Posted: 08 Nov 2012 at 4:33pm
	I have a sticky issue for a Mini DisplayPort connector with through hole pins. The holes are recommended at 0.6mm but there are holes only 1mm apart! So, in order to maintain a clearance of say 0.15mm between pads I get 0.85mm diameter pad (compared to recommended pad of 1.1mm for 0.6mm hole). So, the question is, which 'rules' are best to follow. I am inclined towards maintaining the pad to pad spacing and having a tight annular ring, rather than compromise pad to pad spacing for a larger ring and risk bridging. Any guidance on this appreciated. Cheers!



DaveCowl Members Profile Send Private Message Find Members Posts Add to Buddy List Advanced User Joined: 18 Oct 2012 Location: Santa Clara, CA Status: Offline Points: 161	Post Options Post Reply Quote DaveCowl Report Post Thanks(0) Quote Reply Posted: 08 Nov 2012 at 4:57pm
	It looks like the pins are rectangular, max 0.25mm wide, so maybe I can also shrink the hole from 0.6mm to .55 or even 0.5mm...?

Tom H Members Profile Send Private Message Find Members Posts Add to Buddy List Admin Group Joined: 05 Jan 2012 Location: San Diego, CA Status: Offline Points: 5718	Post Options Post Reply Quote Tom H Report Post Thanks(0) Quote Reply Posted: 08 Nov 2012 at 5:39pm
	A 0.25 mm square pin size could fit easily into a 0.55 mm hole, but still that's a 0.95 mm pad per Proportional Padstack. Download the IPC-7351 Padstack Calculator - http://www.pcblibraries.com/forum/ipc7251-pth-padstack-calculator_topic596.html It has Least, Nominal & Most environment padstack calculations. Great resource tool for when you're in a jam.