Design SMT pad for magnet wire

Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic

   Is there a resource/spec (or a method in this tool) for properly sizing rectangular pads onto which a specific AWG magnet wire would be attached?  I have a tool (Saturn PCB Toolkit) which gives me the diameter of any AWG so I just need a pad design.

I considered winging it by treating the wire as a MELF SMT part with the pad length L being long (ie, 2mm) but I was wondering if there was any 'better practice'.  Web searching has yielded nothing specific yet.

I have PCB Lib Expert 2013.17

Thanks,

Billy

Author	Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic
Evenkeel Members Profile Send Private Message Find Members Posts Add to Buddy List Advanced User Joined: 13 Dec 2012 Location: USA Status: Offline Points: 145	Post Options Post Reply Quote Evenkeel Report Post Thanks(0) Quote Reply Topic: Design SMT pad for magnet wire Posted: 12 Dec 2013 at 9:14am
	Is there a resource/spec (or a method in this tool) for properly sizing rectangular pads onto which a specific AWG magnet wire would be attached? I have a tool (Saturn PCB Toolkit) which gives me the diameter of any AWG so I just need a pad design. I considered winging it by treating the wire as a MELF SMT part with the pad length L being long (ie, 2mm) but I was wondering if there was any 'better practice'. Web searching has yielded nothing specific yet. I have PCB Lib Expert 2013.17 Thanks, Billy



Tom H Members Profile Send Private Message Find Members Posts Add to Buddy List Admin Group Joined: 05 Jan 2012 Location: San Diego, CA Status: Offline Points: 5718	Post Options Post Reply Quote Tom H Report Post Thanks(0) Quote Reply Posted: 12 Dec 2013 at 7:18pm
	Billy... we rely on IPC standards for solder joint goals and I don't know of any standard for soldering wires to a SMT pad. We can't recommend a solution to your issue.
	Stay connected - follow us! X - LinkedIn