PCB Libraries Forum Homepage
Forum Home Forum Home > General > General Discussion
  New Posts New Posts RSS Feed - Pad Stack With Notch
  FAQ FAQ  Forum Search   Events   Register Register  Login Login

Pad Stack With Notch
 Post Reply Post Reply
Author
Message
  Topic Search Topic Search  Topic Options Topic Options
rdl86626 View Drop Down
Advanced User
Advanced User
Avatar

Joined: 20 Jul 2012
Location: Hollister, CA
Status: Offline
Points: 83 		Post Options Post Options   Thanks (0) Thanks(0)   Quote rdl86626 Quote  Post ReplyReply Direct Link To This Post Topic: Pad Stack With Notch
    Posted: 10 Jan 2014 at 8:29am
Hi,
  
Is it possible to create a part (say a surface mount cap) with one pad having a notch cut out at one corner?
Back to Top
Back to Top
Tom H View Drop Down
Admin Group
Admin Group
Avatar

Joined: 05 Jan 2012
Location: San Diego, CA
Status: Offline
Points: 5718 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Tom H Quote  Post ReplyReply Direct Link To This Post Posted: 10 Jan 2014 at 8:53am

Absolutely! Use the Footprint Designer module to define your custom padstack.


Stay connected - follow us! X - LinkedIn
Back to Top
Nick B View Drop Down
Admin Group
Admin Group


Joined: 02 Jan 2012
Status: Offline
Points: 1908 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Nick B Quote  Post ReplyReply Direct Link To This Post Posted: 10 Jan 2014 at 3:13pm

You can view how to create/define custom padstacks in most of the videos found here:

http://www.pcblibraries.com/training
Stay connected - follow us! X - LinkedIn
Back to Top
Nick B View Drop Down
Admin Group
Admin Group


Joined: 02 Jan 2012
Status: Offline
Points: 1908 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Nick B Quote  Post ReplyReply Direct Link To This Post Posted: 12 Jan 2014 at 8:51pm

In the Pad Stack Designer Select –

  1. Surface Mount
  2. Pad Shape Rectangle
  3. Enter your pad size length and width
  4. Corner Style “BOTH” (so that you can also create radius corners on the remaining 3 corners)
  5. Chamfer Size
  6. Chamfer Location

As far as creating a "Notch" like an "L" shaped pad, FP Designer can not do that yet.

 
Stay connected - follow us! X - LinkedIn
Back to Top
 Post Reply Post Reply

Forum Jump Forum Permissions View Drop Down



This page was generated in 0.186 seconds.