Question about Oscillator, L-Bend definition

Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic

   Hi.

Is the value for E2 supposed to be the NOM dimension for the center of the contact surface on the lead/pin?  I am using this land pattern, not for an oscillator, but for an LED that has "L" leads (http://www.cree.com/~/media/Files/Cree/LED%20Components%20and%20Modules/HB/Data%20Sheets/CLP6CFKB%28933%29.pdf - see sheet 7).  It is not entirely clear if this is for the body or leads.

Kory

Author	Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic
KoryJ Members Profile Send Private Message Find Members Posts Add to Buddy List New User Joined: 14 May 2012 Location: Portland, OR Status: Offline Points: 5	Post Options Post Reply Quote KoryJ Report Post Thanks(0) Quote Reply Topic: Question about Oscillator, L-Bend definition Posted: 05 Jun 2013 at 9:46am
	Hi. Is the value for E2 supposed to be the NOM dimension for the center of the contact surface on the lead/pin? I am using this land pattern, not for an oscillator, but for an LED that has "L" leads (http://www.cree.com/~/media/Files/Cree/LED%20Components%20and%20Modules/HB/Data%20Sheets/CLP6CFKB%28933%29.pdf - see sheet 7). It is not entirely clear if this is for the body or leads. Kory



Tom H Members Profile Send Private Message Find Members Posts Add to Buddy List Admin Group Joined: 05 Jan 2012 Location: San Diego, CA Status: Offline Points: 5716	Post Options Post Reply Quote Tom H Report Post Thanks(0) Quote Reply Posted: 05 Jun 2013 at 12:10pm
	Yes, the red * (required entry) is located in the "Nominal" column.