PCB Libraries Forum Homepage
Forum Home Forum Home > PCB Footprint Expert > Product Suggestions
  New Posts New Posts RSS Feed - Cylindrical End Cap Devices - Toe/Heel/Side Goals
  FAQ FAQ  Forum Search   Events   Register Register  Login Login

Cylindrical End Cap Devices - Toe/Heel/Side Goals
 Post Reply Post Reply
Author
Message
  Topic Search Topic Search  Topic Options Topic Options
jde0503 View Drop Down
Active User
Active User


Joined: 10 May 2023
Status: Offline
Points: 13 		Post Options Post Options   Thanks (0) Thanks(0)   Quote jde0503 Quote  Post ReplyReply Direct Link To This Post Topic: Cylindrical End Cap Devices - Toe/Heel/Side Goals
    Posted: 20 Jul 2023 at 9:40am
Devices with Cylindrical End Cap terminations should have different groups of toe/heel/side solder goals based on device height/length/width.

This has been done with rectangular end cap devices and should similarly be done for cylindrical.

There's no reason to have a part that is twice the size have the same toe/heel/side solder goals. This leads to wildly undersized or oversized pads.
Back to Top
Back to Top
Tom H View Drop Down
Admin Group
Admin Group
Avatar

Joined: 05 Jan 2012
Location: San Diego, CA
Status: Offline
Points: 5718 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Tom H Quote  Post ReplyReply Direct Link To This Post Posted: 22 Dec 2023 at 9:37am
We granted your wish and turned MELF solder joint goals into incremental pad stacks per the Nominal Diameter in V24.02 pre-release dated today 12/22/2023. 

New Nominal Diameter Ranges –

  • Dia. < 1.00
  • Dia. >= 1.00, < 2.00
  • Dia. >= 2.00, < 3.00
  • Dia. >= 3.00, < 4.00
  • Dia. > 4.00
Now you can control the Toe, Heel and Side for MELF Resistors, Diodes and Fuses. 

Thank you for recommending this feature. 

V24.02 will be officially released next week - www.pcblibraries.com/downloads
Stay connected - follow us! X - LinkedIn
Back to Top
 Post Reply Post Reply

Forum Jump Forum Permissions View Drop Down



This page was generated in 0.328 seconds.