PCB Libraries Forum Homepage
Forum Home Forum Home > PCB Footprint Expert > Questions & Answers
  New Posts New Posts RSS Feed - "E" dimension in TO-92
  FAQ FAQ  Forum Search   Events   Register Register  Login Login

"E" dimension in TO-92

 Post Reply Post Reply
Author
Message
Batiskaff View Drop Down
Advanced User
Advanced User


Joined: 30 Apr 2018
Status: Offline
Points: 65
Post Options Post Options   Thanks (0) Thanks(0)   Quote Batiskaff Quote  Post ReplyReply Direct Link To This Post Topic: "E" dimension in TO-92
    Posted: 19 Feb 2020 at 10:22am
In TO-92 family, is "E" dimension spacing from body edge to body corner
or from body edge to terminal edge?
Or may be from edge of body to terminal center, for example
E(in calculator)=d(in drawing)
Back to Top
Back to Top
Jeff.M View Drop Down
Admin Group
Admin Group


Joined: 16 May 2012
Location: San Diego
Status: Offline
Points: 477
Post Options Post Options   Thanks (0) Thanks(0)   Quote Jeff.M Quote  Post ReplyReply Direct Link To This Post Posted: 19 Feb 2020 at 12:06pm
Notice that in the TO92, one edge of all terminals fall on a line that bisects the case diameter were it to be totally round. The 'E' dimension is from the flat side to that line.
Stay connected - follow us! Twitter - LinkedIn
Back to Top
 Post Reply Post Reply

Forum Jump Forum Permissions View Drop Down



This page was generated in 0.141 seconds.