Question about Oscillator, L-Bend definition |
Post Reply |
Author | |
KoryJ
New User Joined: 14 May 2012 Location: Portland, OR Status: Offline Points: 5 |
Post Options
Thanks(0)
Posted: 05 Jun 2013 at 9:46am |
Hi.
Is the value for E2 supposed to be the NOM dimension for the center of the contact surface on the lead/pin? I am using this land pattern, not for an oscillator, but for an LED that has "L" leads (http://www.cree.com/~/media/Files/Cree/LED%20Components%20and%20Modules/HB/Data%20Sheets/CLP6CFKB%28933%29.pdf - see sheet 7). It is not entirely clear if this is for the body or leads. Kory |
|
Tom H
Admin Group Joined: 05 Jan 2012 Location: San Diego, CA Status: Offline Points: 5717 |
Post Options
Thanks(0)
|
Yes, the red * (required entry) is located in the "Nominal" column.
|
|
Post Reply | |
Tweet |
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |