PCB Libraries Forum Homepage
Forum Home Forum Home > Libraries > Footprints / Land Patterns > OrCAD Layout
  New Posts New Posts RSS Feed - Via Naming Convention
  FAQ FAQ  Forum Search   Events   Register Register  Login Login

Via Naming Convention

 Post Reply Post Reply
Author
Message
bnoel View Drop Down
Active User
Active User
Avatar

Joined: 14 Mar 2014
Location: Western NY
Status: Offline
Points: 14
Post Options Post Options   Thanks (0) Thanks(0)   Quote bnoel Quote  Post ReplyReply Direct Link To This Post Topic: Via Naming Convention
    Posted: 13 Dec 2016 at 2:05pm
Isn't it time to drop the zz from the following via naming conventinon:  via-xx-yy-zz  where xx is the pad diameter, yy is the hole diameter and zz is the anti-pad diameter?  We haven't been using negative planes in years and I believe most EDA tools have gotten away from them too.  Thoughts.
Back to Top
Back to Top
Tom H View Drop Down
Admin Group
Admin Group
Avatar

Joined: 05 Jan 2012
Location: San Diego, CA
Status: Offline
Points: 5716
Post Options Post Options   Thanks (0) Thanks(0)   Quote Tom H Quote  Post ReplyReply Direct Link To This Post Posted: 13 Dec 2016 at 2:40pm
Where is a via naming convention at?

The anti-pad is for both Positive and Negative planes and it represents a very important value in the pad stack, especially for vias.

If the anti-pad diameter should not be larger than the pad annular ring + trace space.

You do not want to run high speed signal traces over a plane anti-pad. The plane is the signal return path and trace couples with the plane.

In the via pad stack, you have to define the pad, hole, anti-pad and direct plane connect (flood over) for a normal copper pour plane flood.

Stay connected - follow us! X - LinkedIn
Back to Top
 Post Reply Post Reply

Forum Jump Forum Permissions View Drop Down



This page was generated in 0.219 seconds.