Print Page | Close Window

Entended Footprint Names

Printed From: PCB Libraries Forum
Category: PCB Footprint Expert
Forum Name: Questions & Answers
Forum Description: issues and technical support
URL: https://www.PCBLibraries.com/forum/forum_posts.asp?TID=1803
Printed Date: 27 Nov 2024 at 6:05am


Topic: Entended Footprint Names
Posted By: lalexman
Subject: Entended Footprint Names
Date Posted: 09 Dec 2015 at 9:14am

uploads/545/pict.docx" rel="nofollow - uploads/545/pict.docx

I guess word pictures are not saved.

 
Why is the footprint width in the attached picture  87 in the name at the top . Shouldn't it be 38 ?


Replies:
Posted By: Nick B
Date Posted: 09 Dec 2015 at 9:47am
I cannot open the docx file, it seems corrupted. Can you upload a JPG or PNG file instead?

-------------
Stay connected - follow us! https://twitter.com/PCBLibraries" rel="nofollow - X - http://www.linkedin.com/company/pcb-libraries-inc-/" rel="nofollow - LinkedIn

Posted By: lalexman
Date Posted: 09 Dec 2015 at 1:07pm
Here is a jpeg. uploads/545/1234.jpg" rel="nofollow - uploads/545/1234.jpg

Posted By: lalexman
Date Posted: 14 Dec 2015 at 8:28am
Hi Nick, Have you seen the jpeg ?

Posted By: Tom H
Date Posted: 14 Dec 2015 at 9:08am
The Extended Footprint Name "L" for all Gullwing Lead parts is "L = the full tolerance range".

i.e.: 1.25 mm minus 0.40 mm = 0.87 mm

I do not know where you came up with 0.38 mm



-------------
Stay connected - follow us! https://twitter.com/PCBLibraries" rel="nofollow - X - http://www.linkedin.com/company/pcb-libraries-inc-/" rel="nofollow - LinkedIn

Posted By: lalexman
Date Posted: 14 Dec 2015 at 9:12am
I thought the extension was going to be the lead with or length ?. What good does the tolerance value do for us?  the .38MM is the nominal lead width.

Posted By: Tom H
Date Posted: 14 Dec 2015 at 12:23pm
What good does the Terminal Length value do for you?

Example:
If the Terminal Lead length was 0.38 mm and the Tolerance was +/- 0.4 mm
If the same package dimensions on a different part had a Terminal Lead Length of 0.38 mm with a +/- 0.6 mm tolerance
If the same package dimensions on a different part had a Terminal Lead Length of 0.38 mm with a +/- 0.3 mm tolerance

The end result is the pad length would be different under every scenario but would produce the same exact footprint name.

The Total Tolerance has a higher priority over a fixed value with multiple Tolerances.



-------------
Stay connected - follow us! https://twitter.com/PCBLibraries" rel="nofollow - X - http://www.linkedin.com/company/pcb-libraries-inc-/" rel="nofollow - LinkedIn

Posted By: lalexman
Date Posted: 14 Dec 2015 at 1:26pm
You could say the same thing if the terminal lengths were different and the tolerance was the same. its just as easy to add a -1 or -2 to the footprint name since you would have to go back and look at the actual min max values for the pin length any ways. Guess there is not real easy solution unless you create the footprint name with all the parameters.
Thanks


Print Page | Close Window