0201 Capacitor Corner Radius Pad

Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic

   Hi all,
I created my first 0201 capacitor and I feel that using a Corner Radius Size Limit parameter= 0.10 mm could be "risky" (I used Fab Tol= 0, Placement Tol=0).

I know that some manufacturers use 0.05 mm.

My component is GRM033R61C104KE14D from Murata

Which is your recommendation for this tiny component sizes?

Waiting for your comments.

David

Author	Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic
dramos Members Profile Send Private Message Find Members Posts Add to Buddy List Advanced User Joined: 18 Feb 2021 Status: Offline Points: 93	Post Options Post Reply Quote dramos Report Post Thanks(0) Quote Reply Topic: 0201 Capacitor Corner Radius Pad Posted: Yesterday at 4:09am
	Hi all, I created my first 0201 capacitor and I feel that using a Corner Radius Size Limit parameter= 0.10 mm could be "risky" (I used Fab Tol= 0, Placement Tol=0). I know that some manufacturers use 0.05 mm. My component is GRM033R61C104KE14D from Murata Which is your recommendation for this tiny component sizes? Waiting for your comments. David



Tom H Members Profile Send Private Message Find Members Posts Add to Buddy List Admin Group Joined: 05 Jan 2012 Location: San Diego, CA Status: Offline Points: 6035	Post Options Post Reply Quote Tom H Report Post Thanks(0) Quote Reply Posted: Yesterday at 8:30am
	Rule of thumb - any package less than 1.00 mm in length or width should have 0.05 mm corner radius pads. You can use the 'SMD Pad Stack Rules' in the side panel of the calculator to change the corner radius. Or you can move the calculator footprint to FP Designer to permanently save the 0.05 mm corner radius to FPX library format. But we recommend that you first setup everything in the calculator before moving to FP Designer so you won't have to edit the pad stack in FP Designer. FP Designer saves all your settings to the FPX library. You can rename the Footprint Name in the Library Editor.
	Stay connected - follow us! X - LinkedIn

dramos Members Profile Send Private Message Find Members Posts Add to Buddy List Advanced User Joined: 18 Feb 2021 Status: Offline Points: 93	Post Options Post Reply Quote dramos Report Post Thanks(0) Quote Reply Posted: 10 hours 13 minutes ago at 2:59am
	Hi Tom and Team, Many thanks for your fast response. Does it mean that we should apply the same rule of thumb to 0402 case components or even 0603 components? I am thinking on resistors ... Thanks for spreading your knowledge :) david

Tom H Members Profile Send Private Message Find Members Posts Add to Buddy List Admin Group Joined: 05 Jan 2012 Location: San Diego, CA Status: Offline Points: 6035	Post Options Post Reply Quote Tom H Report Post Thanks(0) Quote Reply Posted: 4 hours 31 minutes ago at 8:41am
	0402 is not 'Less than 1.00 mm'. It looks OK with a 0.10 mm corner radius. Watch out for excessive package tolerances. This package is 1.00 L x 0.50 W x 0.55 H with a 0.10 tolerance on all dimensions.
	Stay connected - follow us! X - LinkedIn

dramos Members Profile Send Private Message Find Members Posts Add to Buddy List Advanced User Joined: 18 Feb 2021 Status: Offline Points: 93	Post Options Post Reply Quote dramos Report Post Thanks(0) Quote Reply Posted: 3 hours 60 minutes ago at 9:12am
	Hi Tom and Team, Thanks for the clarification, when you mentioned length , width I was surprised if you were referring to any of the values. I was a little bit in shock!! hahahahaha Thanks and regards, david