Library Expert 2015.13 Released!!

NEW:

• Setup Preferences:
• Totally redesigned GUI to make this feature more User Friendly
• User Preferences have been removed
• Default Preferences are now just “Preferences”
• FP Designer – Drawing Button:
• Added new polarity marking for Triangles, Diode Symbols and Lines
• Added Assembly Drawing Top layer to polarity markings
• Library Editor:
• Added a new feature for creating a .bak backup file when you save your FPX file
  

FIXED / ENHANCED:

• Calculator:
• Fixed an issue in the DIODFN component family pin re-mapping C & A to A & C
• FP Designer:
• Fixed an issue with keep-outs not following the selections
• Default Preferences:
• Minimum Annular Ring now map correctly to the Calculator parts
• Library Editor:
• Fixed an issue where under certain conditions, deleting and adding parts caused new parts not to be saved
• 3D STEP:
• Updated the LCC component family for the rectangular version
• CR-5000:
• PTH holes should now be translating properly
• Fixed a problem with 180 degree arcs in pads getting flattened by CR-5000. They were converted into two 90 degree arcs, which should achieve the desired result.
• Pads on the Inner layer now have their No Connect back
• PADS Layout:
• Fixed an issue that was causing the PADS to FPX conversion to not handle pad offsets properly
• Master FPX:
• Updated SM FPX in www.pcblibraries.com/downloads