Three Pin Ferrite Beads

Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic

Has anyone dealt with the Ferrite Beads like the Murate NFE31P parts that have a barrel with a middle GND pin on a MELF like construction?

The recommended footprint from Murata is very odd and of course it defies naming conventions or standard footprint generation.

The land pattern that I inherited basically looks like a 1206 with an extra pad in the middle, but that is far from the recommended shape, which is odd since the end pads are narrower than the part itself, though the end caps are round...

I will try to include the footprint for reference.

Thoughts or recommendations? Just run with the recommended land pattern?

Author	Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic
DaveCowl Members Profile Send Private Message Find Members Posts Add to Buddy List Advanced User Joined: 18 Oct 2012 Location: Santa Clara, CA Status: Offline Points: 161	Post Options Post Reply Quote DaveCowl Report Post Thanks(0) Quote Reply Topic: Three Pin Ferrite Beads Posted: 25 Oct 2012 at 10:10am
	Has anyone dealt with the Ferrite Beads like the Murate NFE31P parts that have a barrel with a middle GND pin on a MELF like construction? The recommended footprint from Murata is very odd and of course it defies naming conventions or standard footprint generation. The land pattern that I inherited basically looks like a 1206 with an extra pad in the middle, but that is far from the recommended shape, which is odd since the end pads are narrower than the part itself, though the end caps are round... I will try to include the footprint for reference. Thoughts or recommendations? Just run with the recommended land pattern?



Tom H Members Profile Send Private Message Find Members Posts Add to Buddy List Admin Group Joined: 05 Jan 2012 Location: San Diego, CA Status: Offline Points: 5718	Post Options Post Reply Quote Tom H Report Post Thanks(0) Quote Reply Posted: 25 Oct 2012 at 10:15am
	I would go with the mfr. recommended pattern. The CM must have tested it on a reference design to proof it out. This package is a unique one-of-a-kind non-standard part. It needs to be built once, built right and never built again by anyone. But we'll get there soon.

DaveCowl Members Profile Send Private Message Find Members Posts Add to Buddy List Advanced User Joined: 18 Oct 2012 Location: Santa Clara, CA Status: Offline Points: 161	Post Options Post Reply Quote DaveCowl Report Post Thanks(0) Quote Reply Posted: 25 Oct 2012 at 10:30am
	The strangest thing about the pattern is that the white areas are (from the best I can tell) devoid of solder mask. Which is a pretty huge solder mask opening, that is essentially 'open ended' on the top and bottom. The solder mask pattern is the light grey. My tendency would be to have a more typical solder mask pattern that is essentially the inverse of the pads. Perhaps the recommendation is the minimum required solder mask? I am not sure what to make of this...