|
|
Are librarians adding a pin one dot to tiny comps? |
Post Reply 
|
| Author | |
lsday 
Active User 
Joined: 15 Dec 2014 Status: Offline Points: 24 |
 Post Options
 Thanks(0)
 Quote Reply
 Topic: Are librarians adding a pin one dot to tiny comps?Posted: 29 Mar 2019 at 8:30am |
|
I am getting quite a few die size components. I am wondering about the pin one marking. Should I mark it? Should the dot size be less than 20 mils?
|
|
 |
|
|
|
|
Tom H
Admin Group 
Joined: 05 Jan 2012 Location: San Diego, CA Status: Offline Points: 5719 |
Post Options
Thanks(0)
Quote Reply
Posted: 29 Mar 2019 at 8:37am |
|
A 15 Mil dot is about the smallest for both the fabrication shop and the human eye.
Why not box Pin 1 in a square? Or are the pins too close? These are the Polarity Marking in Library Expert.  |
|
|
|
|
lsday
Active User
Joined: 15 Dec 2014 Status: Offline Points: 24 |
Post Options
Thanks(0)
Quote Reply
Posted: 29 Mar 2019 at 8:56am |
|
I will try the box method. Thank you Tom.
|
|
|
|
|
Tom H
Admin Group
Joined: 05 Jan 2012 Location: San Diego, CA Status: Offline Points: 5719 |
Post Options
Thanks(0)
Quote Reply
Posted: 29 Mar 2019 at 9:05am |
|
If you're in FP Designer, temporarily move the origin to Pin 1 and then place the box a 0,0 and make the line width minimum 0.10 and make the box 0.15 larger than the pad.
Box size = 0.10 line with 0.10 space + pad size. If you use a 0.12 line / 0.12 space then make the box 0.18 larger than the pad. |
|
|
|
|
Post Reply
|
|
| Tweet |
| Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |
Topic Options