IPC-7251 & 3-Tier PTH Pad Stack Obsolete

Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic

   In 2009 IPC (Dieter
Bergman, John Perry and Tom Hausherr) started progress on a land pattern
standard for through-hole components called IPC-7251. There were meetings where
Gary Ferrari attended by webcast. The 3-Tier pad stack annular ring for
through-hole was based off the same precedent for SMD where the Least, Nominal
and Most environments had a single value for Toe, Heel and Side. IPC-7251 never
got published and progress was discontinued on October 1, 2014 by the IPC 1-13
Land Pattern committee as they decided to instead add it to IPC-7351C which
we’re currently working on. 

The IPC-7251
through-hole pad stack was inherently flawed due to the 3-Tier annular ring
concept that the same Annular Ring Value could be used for any hole size. An
example of this would be: The Nominal Environment annular ring (AR) was set to
8 mils. That means that a 10 mil hole had a 8 mil AR and a 20 mil hole had a 8
mil AR and the 40 mil hole had a 8 mil AR and a 80 mil hole had a 8 mil AR. The
flaws are apparent in that small holes require small AR and large holes require
a larger AR for solder volume, strength, voltage current, heat, etc. Even
though LP Wizard and Library Expert supported IPC-7251, the through-hole
default in both programs was “Proportional Pad Stacks” due to the fact that
IPC-7251 was an unreleased standard. 

Author	Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic
Tom H Members Profile Send Private Message Find Members Posts Add to Buddy List Admin Group Joined: 05 Jan 2012 Location: San Diego, CA Status: Offline Points: 5719	Post Options Post Reply Quote Tom H Report Post Thanks(0) Quote Reply Topic: IPC-7251 & 3-Tier PTH Pad Stack Obsolete Posted: 05 Nov 2014 at 10:13am
	In 2009 IPC (Dieter Bergman, John Perry and Tom Hausherr) started progress on a land pattern standard for through-hole components called IPC-7251. There were meetings where Gary Ferrari attended by webcast. The 3-Tier pad stack annular ring for through-hole was based off the same precedent for SMD where the Least, Nominal and Most environments had a single value for Toe, Heel and Side. IPC-7251 never got published and progress was discontinued on October 1, 2014 by the IPC 1-13 Land Pattern committee as they decided to instead add it to IPC-7351C which we’re currently working on. The IPC-7251 through-hole pad stack was inherently flawed due to the 3-Tier annular ring concept that the same Annular Ring Value could be used for any hole size. An example of this would be: The Nominal Environment annular ring (AR) was set to 8 mils. That means that a 10 mil hole had a 8 mil AR and a 20 mil hole had a 8 mil AR and the 40 mil hole had a 8 mil AR and a 80 mil hole had a 8 mil AR. The flaws are apparent in that small holes require small AR and large holes require a larger AR for solder volume, strength, voltage current, heat, etc. Even though LP Wizard and Library Expert supported IPC-7251, the through-hole default in both programs was “Proportional Pad Stacks” due to the fact that IPC-7251 was an unreleased standard.
	Stay connected - follow us! X - LinkedIn