|
|
SODFL & SOTFL |
Post Reply 
|
| Author | |
mohamedjubair.k 
Active User 
Joined: 05 Sep 2022 Status: Offline Points: 26 |
 Post Options
 Thanks(0)
 Quote Reply
 Topic: SODFL & SOTFLPosted: 03 Mar 2023 at 4:13am |
|
Hi Tom,
I read the IPC-7351 document and I did not see solder joint goal table for flat leads [SODFL and SOTFL] components. But in library calculator Toe joint value found as 0.20 mm. From where did they find this value. Is this 0.20 mm is fine for Toe end.  |
|
 |
|
|
|
|
Tom H
Admin Group 
Joined: 05 Jan 2012 Location: San Diego, CA Status: Offline Points: 5718 |
Post Options
Thanks(0)
Quote Reply
Posted: 03 Mar 2023 at 8:59am |
|
Per IPC J-STD-001 Standard, the Toe value is determined by the Terminal Lead Thickness.
This is the example of the Gull Wing Terminal Lead form.
 |
|
|
|
|
mohamedjubair.k
Active User
Joined: 05 Sep 2022 Status: Offline Points: 26 |
Post Options
Thanks(0)
Quote Reply
Posted: 03 Mar 2023 at 6:10pm |
|
Hi Tom,
Thank you for you quick reply. Actually I need information about Flat Lead component like attached.  |
|
|
|
|
Tom H
Admin Group
Joined: 05 Jan 2012 Location: San Diego, CA Status: Offline Points: 5718 |
Post Options
Thanks(0)
Quote Reply
Posted: 04 Mar 2023 at 9:45am |
|
It's the same concept. You take the "Nominal c" dimension (and round up to the nearest 0.05) and that is your Toe goal.
Anything bigger than that is a waste of PCB real-estate and excess solder. The main strength in the solder joint is under the terminal lead.  |
|
|
|
|
mohamedjubair.k
Active User
Joined: 05 Sep 2022 Status: Offline Points: 26 |
Post Options
Thanks(0)
Quote Reply
Posted: 05 Mar 2023 at 8:53am |
|
Thank you so much Tom!
|
|
|
|
|
Post Reply
|
|
| Tweet |
| Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |
Topic Options