|
|
TO-220 Package Footprint name |
Post Reply 
|
| Author | |
Bharat_Verma 
Advanced User 
Joined: 10 Feb 2021 Status: Offline Points: 63 |
 Post Options
 Thanks(0)
 Quote Reply
 Topic: TO-220 Package Footprint namePosted: 01 Jun 2021 at 9:42pm |
|
Hi Tom,
I have a Question regarding Footprint name for flange mount TO-220 VERTICAL . There are two different style or pattern of lead location for which Footprint name remain same. See attached example. Why it was not differentiated ?   |
|
 |
|
|
|
|
Tom H
Admin Group 
Joined: 05 Jan 2012 Location: San Diego, CA Status: Offline Points: 5718 |
Post Options
Thanks(0)
Quote Reply
Posted: 02 Jun 2021 at 7:41am |
|
Because IPC did not provide any land pattern naming convention guidance for Vertical or Horizontal Flange Mount component family.
I guess we could create our own since IPC did not address this in the IPC-7351 guideline. What would you propose? |
|
|
|
|
Tom H
Admin Group
Joined: 05 Jan 2012 Location: San Diego, CA Status: Offline Points: 5718 |
Post Options
Thanks(1)
Quote Reply
Posted: 03 Jun 2021 at 11:34am |
|
The only reason to spread the pins out is because the pin pitch is too small and the pad size too large and they short together.
The Footprint Name includes the pin pitch. Ideally you want all the pads in a single row, but if the pads short together then you must bend the terminal leads to separate the pads so they do not short. The footprint name doesn't change because you only have 2 options. Pads in a row or staggered pads if the pin pitch is too tight. |
|
|
|
|
Post Reply
|
|
| Tweet |
| Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |
Topic Options