2012.43 Released!

Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic

Version 2012.43 has just been released!

FIXED:
OrCAD PCB/Allegro – Fixed an issue with hidden pins not being filtered
PADS – Fixed Thermal Pad orientation when chamfered corners were used
PADS – When ‘Map Alphanumeric pins’ is unchecked, the alphanumeric pins will properly be moved from the Part-Type to the Decal
PADS – When extended layers is selected and a part type/decal is output, the extended layer selection will now be properly recognized
PADS – Fixed a problem that was causing through-hole anti-pads generated at half their size
Ultiboard – Added a &ASC; to the LandPatternName so that they import properly
Ultiboard – Set the visibility of the pin attribute to ‘2’ to match what had been done in the past
TARGET 3001! – Pins now properly have pads set to layer 2 instead of layer 100
Calculator – Header’s switching for millimeter to inch units
Calculator – Thermal Pad dimensions being swapped 

Author	Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic
Nick B Members Profile Send Private Message Find Members Posts Add to Buddy List Admin Group Joined: 02 Jan 2012 Status: Offline Points: 1908	Post Options Post Reply Quote Nick B Report Post Thanks(0) Quote Reply Topic: 2012.43 Released! Posted: 11 Feb 2013 at 1:28pm
	Version 2012.43 has just been released! FIXED: OrCAD PCB/Allegro – Fixed an issue with hidden pins not being filtered PADS – Fixed Thermal Pad orientation when chamfered corners were used PADS – When ‘Map Alphanumeric pins’ is unchecked, the alphanumeric pins will properly be moved from the Part-Type to the Decal PADS – When extended layers is selected and a part type/decal is output, the extended layer selection will now be properly recognized PADS – Fixed a problem that was causing through-hole anti-pads generated at half their size Ultiboard – Added a &ASC; to the LandPatternName so that they import properly Ultiboard – Set the visibility of the pin attribute to ‘2’ to match what had been done in the past TARGET 3001! – Pins now properly have pads set to layer 2 instead of layer 100 Calculator – Header’s switching for millimeter to inch units Calculator – Thermal Pad dimensions being swapped