|
|
Use Manufacturer's Fecommended Footprint? |
Post Reply 
|
| Author | |
EW_FrankO 
Active User 
Joined: 29 Feb 2016 Status: Offline Points: 10 |
 Post Options
 Thanks(0)
 Quote Reply
 Topic: Use Manufacturer's Fecommended Footprint?Posted: 29 Feb 2016 at 3:59am |
|
Hello,
Maybe it's a feature and I do not understand this feature. ... under: Footprint → Dimensions → Use manufacturer's recommended dimensions. There is a radiobox. If I select (Use manufacturer's recommended dimensions), I can edit. If I unselect, it is greyed out. ... and no Button to restore the manufacturer's recommended dimensions. Which Manufacturer's Recommended Dimensions does it effect? |
|
 |
|
|
|
|
Tom H
Admin Group 
Joined: 05 Jan 2012 Location: San Diego, CA Status: Offline Points: 5717 |
Post Options
Thanks(0)
Quote Reply
Posted: 29 Feb 2016 at 8:10am |
|
After you enter the physical component dimensions you can select the Footprint tab and enter the mfr. recommended pad sizes and spacing. The you can look at the viewer and see where the pad is in relation to the Component Terminal Leads. If the Terminal Leads fall off the pad then the mfr. recommended pattern is faulty. If you get good results then add the data to your FPX file. Then you can remove the Footprint Dimensions and see the IPC-7351 pattern. If you want to recall the Mfr. Recommended Footprint reopen the part in the FPX file that you saved. |
|
|
|
|
Post Reply
|
|
| Tweet |
| Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |
Topic Options