Pins too tight

Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic

   uploads/45/Connector.jpg

Hello. Using IPC density level C (Least) for the padstacks associated with pins 13-16 of the enclosed connector footprint I find less the 5mils of clearance between pads. (4.8mils)  I had to make the pad even smaller than what Level C recommended (c140h90)  Any comments? 

Author	Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic
budnoel Members Profile Send Private Message Find Members Posts Add to Buddy List Active User Joined: 16 Mar 2012 Status: Offline Points: 17	Post Options Post Reply Quote budnoel Report Post Thanks(0) Quote Reply Topic: Pins too tight Posted: 12 Nov 2012 at 12:47pm
	uploads/45/Connector.jpg Hello. Using IPC density level C (Least) for the padstacks associated with pins 13-16 of the enclosed connector footprint I find less the 5mils of clearance between pads. (4.8mils) I had to make the pad even smaller than what Level C recommended (c140h90) Any comments?



DaveCowl Members Profile Send Private Message Find Members Posts Add to Buddy List Advanced User Joined: 18 Oct 2012 Location: Santa Clara, CA Status: Offline Points: 161	Post Options Post Reply Quote DaveCowl Report Post Thanks(0) Quote Reply Posted: 12 Nov 2012 at 5:02pm
	You are not alone. I have a similar issue with a mini DisplayPort connector. You can't space 1mm pads 1mm apart. I don't have a good answer for this problem but think that pad clearance is probably more important than annular ring...?!

Tom H Members Profile Send Private Message Find Members Posts Add to Buddy List Admin Group Joined: 05 Jan 2012 Location: San Diego, CA Status: Offline Points: 5716	Post Options Post Reply Quote Tom H Report Post Thanks(0) Quote Reply Posted: 13 Nov 2012 at 7:45am
	Whenever the pin pitch and the hole size conflict with the design rules, I use an oblong pad shape with a minimum pad on the sides and accept drill breakout on the sides (if it happens). I never had any manufacturing problems when using this technique. Sometimes you have to think outside the box. We'll have to introduce this pad shape to the through-hole calculator in V2013.