|
|
Typical or maximum in body size |
Post Reply 
|
| Author | |
Michelle Poh 
New User 
Joined: 07 Jun 2020 Status: Offline Points: 3 |
 Post Options
 Thanks(0)
 Quote Reply
 Topic: Typical or maximum in body sizePosted: 19 Jun 2020 at 2:41am |
|
Hi, I am new here in PCB libraries.
I like to ask about File naming convention. Refering to IPC7351 naming convention, for eg. .LCC + Pin Qty. + P Pitch _ Body Length X Width X Height + L Lead Length X Width
The Body Length X Width X Height is using the typical or max values with reference to datasheets ? regards Michelle
|
|
 |
|
|
|
|
Tom H
Admin Group 
Joined: 05 Jan 2012 Location: San Diego, CA Status: Offline Points: 5718 |
Post Options
Thanks(0)
Quote Reply
Posted: 19 Jun 2020 at 8:21am |
|
The entire Land Pattern Naming Convention uses "Nominal Dimensions" except for "Maximum Height".
The Tolerances would constantly change the Maximum values and users should not use the mfr. Tolerances, but use Tolerances that are in range of your acceptability to reduce the number of Footprints in your library. |
|
|
|
|
Michelle Poh
New User
Joined: 07 Jun 2020 Status: Offline Points: 3 |
Post Options
Thanks(0)
Quote Reply
Posted: 23 Jun 2020 at 1:39am |
|
Thank you very much for your reply, Tom
|
|
|
|
|
Post Reply
|
|
| Tweet |
| Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |
Topic Options