Save MFG Recommended Parametrics |
Post Reply |
Author | |
craig4tone
Advanced User Joined: 29 Nov 2016 Status: Offline Points: 95 |
Post Options
Thanks(0)
Posted: 13 Dec 2016 at 7:38am |
There is an option to enter the manufacturer recommended footprint and override the LE footprint. It would be nice to be able to store the mfg recommended parametrics in the FPX and then check whether to use them or not. Currently, if you uncheck, it reverts those numbers back to the LE calculated pad geometries.
|
|
jgregoire
Active User Joined: 19 Jan 2017 Status: Offline Points: 31 |
Post Options
Thanks(0)
|
This is my #1 peeve with the program. Unchecking the box should not reset the values. When deciding if I want to use the recommended pattern or the calculated pattern, I like to toggle between the two. It's hard for me to think about how similar the two are just by looking at the numbers. If the recommended pattern is not significantly different, I will use the standard footprint to keep our total footprint count low.
|
|
Tom H
Admin Group Joined: 05 Jan 2012 Location: San Diego, CA Status: Offline Points: 5716 |
Post Options
Thanks(0)
|
I'm trying to understand how to implement this feature. I think you're saying this "Insert the component mfr. pattern data and it never goes away and instead of the checkbox turning the mfr. data on/off have the checkbox turn on/off to use mfr. or IPC" |
|
Post Reply | |
Tweet |
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |