3D Steps |
Post Reply |
Author | |
RogerG
New User Joined: 17 Dec 2012 Location: United Kingdom Status: Offline Points: 3 |
Post Options
Thanks(0)
Posted: 16 Feb 2015 at 6:45am |
I have made a new leaded header in the FP Designer but I only get a solid block in the 3D Step. I made an SSOP which came out with all the pins OK. Am I missing something out ? This part was made as user defined package. |
|
Tom H
Admin Group Joined: 05 Jan 2012 Location: San Diego, CA Status: Offline Points: 5718 |
Post Options
Thanks(0)
|
FP Designer only produces a block with radius corners with no terminal leads because 3D models are created with multiple physical component dimensions and FP Designer is a mfr. recommended footprint builder. You get those 3D STEP models from the component manufacturer. If you created a standard Header, why didn't you use the Through-hole Header Calculator? |
|
Tom H
Admin Group Joined: 05 Jan 2012 Location: San Diego, CA Status: Offline Points: 5718 |
Post Options
Thanks(0)
|
You can also request a high quality 3D model via www.pcblibraries.com/POD and search for the mfr. and part number and the website will transition you to "Request a Part" and request a 3D STEP model for that component package.
|
|
RogerG
New User Joined: 17 Dec 2012 Location: United Kingdom Status: Offline Points: 3 |
Post Options
Thanks(0)
|
Tom
The reason for using the FP Designer was that there are addition fixing pins, which the through hole calculator does not cope with. If you could edit them after the basis have been done that would be good.
|
|
Tom H
Admin Group Joined: 05 Jan 2012 Location: San Diego, CA Status: Offline Points: 5718 |
Post Options
Thanks(0)
|
Can you post a link to the mfr. datasheet? I need to see what connector (header) you are building. |
|
Post Reply | |
Tweet |
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |