PCB Libraries Forum Homepage
Forum Home Forum Home > PCB Footprint Expert > Questions & Answers
  New Posts New Posts RSS Feed - 3D Steps
  FAQ FAQ  Forum Search   Events   Register Register  Login Login

3D Steps
 Post Reply Post Reply
Author
Message
  Topic Search Topic Search  Topic Options Topic Options
RogerG View Drop Down
New User
New User
Avatar

Joined: 17 Dec 2012
Location: United Kingdom
Status: Offline
Points: 3 		Post Options Post Options   Thanks (0) Thanks(0)   Quote RogerG Quote  Post ReplyReply Direct Link To This Post Topic: 3D Steps
    Posted: 16 Feb 2015 at 6:45am

I have made a new leaded header in the FP Designer but I only get a solid block in the 3D Step.

I made an SSOP which came out with all the pins OK.

Am I missing something out ?

This part was made as user defined package.

Back to Top
Back to Top
Tom H View Drop Down
Admin Group
Admin Group
Avatar

Joined: 05 Jan 2012
Location: San Diego, CA
Status: Offline
Points: 5718 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Tom H Quote  Post ReplyReply Direct Link To This Post Posted: 16 Feb 2015 at 8:19am

FP Designer only produces a block with radius corners with no terminal leads because 3D models are created with multiple physical component dimensions and FP Designer is a mfr. recommended footprint builder. You get those 3D STEP models from the component manufacturer.

If you created a standard Header, why didn't you use the Through-hole Header Calculator?
Stay connected - follow us! X - LinkedIn
Back to Top
Tom H View Drop Down
Admin Group
Admin Group
Avatar

Joined: 05 Jan 2012
Location: San Diego, CA
Status: Offline
Points: 5718 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Tom H Quote  Post ReplyReply Direct Link To This Post Posted: 16 Feb 2015 at 8:53am
You can also request a high quality 3D model via www.pcblibraries.com/POD and search for the mfr. and part number and the website will transition you to "Request a Part" and request a 3D STEP model for that component package.
Stay connected - follow us! X - LinkedIn
Back to Top
RogerG View Drop Down
New User
New User
Avatar

Joined: 17 Dec 2012
Location: United Kingdom
Status: Offline
Points: 3 		Post Options Post Options   Thanks (0) Thanks(0)   Quote RogerG Quote  Post ReplyReply Direct Link To This Post Posted: 16 Feb 2015 at 9:08am
Tom
The reason for using the FP Designer was that there are addition fixing pins, which the through hole calculator does not cope with. If you could edit them after the basis have been done that would be good. 
Back to Top
Tom H View Drop Down
Admin Group
Admin Group
Avatar

Joined: 05 Jan 2012
Location: San Diego, CA
Status: Offline
Points: 5718 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Tom H Quote  Post ReplyReply Direct Link To This Post Posted: 16 Feb 2015 at 10:28am

Can you post a link to the mfr. datasheet? I need to see what connector (header) you are building.


Stay connected - follow us! X - LinkedIn
Back to Top
 Post Reply Post Reply

Forum Jump Forum Permissions View Drop Down



This page was generated in 0.250 seconds.