PCB Libraries Forum Homepage
Forum Home Forum Home > PCB Footprint Expert > Questions & Answers
  New Posts New Posts RSS Feed - Polarity Bar on Diodes
  FAQ FAQ  Forum Search   Events   Register Register  Login Login

Polarity Bar on Diodes
 Post Reply Post Reply
Author
Message
  Topic Search Topic Search  Topic Options Topic Options
kvachhani View Drop Down
Active User
Active User


Joined: 17 Dec 2018
Status: Offline
Points: 16 		Post Options Post Options   Thanks (0) Thanks(0)   Quote kvachhani Quote  Post ReplyReply Direct Link To This Post Topic: Polarity Bar on Diodes
    Posted: 22 May 2019 at 9:12am
Currently working on Polarized Diode with small footprint. See Attached Lib-Exp-Polarity-Bar.pdf.

Expert complains about creating legend due to small footprint, but does not even create the polarity marking bar. 

If I turn on polarity dot, it creates dot. It would be nice if it created bar for polarity marking even if it can't create silkscreen for Diodes and Polarized Capacitors. 

Thanks,
Ken
Back to Top
Back to Top
Tom H View Drop Down
Admin Group
Admin Group
Avatar

Joined: 05 Jan 2012
Location: San Diego, CA
Status: Offline
Points: 5718 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Tom H Quote  Post ReplyReply Direct Link To This Post Posted: 22 May 2019 at 9:28am
Library Expert does not put Silkscreen Legend on small parts due to the Preference settings in the Drafting section. You Line Width and Gap and preventing Library Expert from adding Legend Outlines. 

However, you have 100% control of all the Legend Marking that you want. 

Any Shape, Size, Location, Filled, Unfilled, Layer using the Drafting Symbols feature in the toolbar. 

These are used when your micro-miniature part violates your Preference Settings. Then you can add anything you want per these shapes: 


 
You add the Polarity Bar and Library Expert will save all your drafting outlines to FPX. 
Stay connected - follow us! X - LinkedIn
Back to Top
kvachhani View Drop Down
Active User
Active User


Joined: 17 Dec 2018
Status: Offline
Points: 16 		Post Options Post Options   Thanks (0) Thanks(0)   Quote kvachhani Quote  Post ReplyReply Direct Link To This Post Posted: 22 May 2019 at 10:43am
Thank you. Can you point me to a document that will walk me thru adding these manually. Are these shapes pre-drawn in the tool somewhere?

thx
Ken
Back to Top
Tom H View Drop Down
Admin Group
Admin Group
Avatar

Joined: 05 Jan 2012
Location: San Diego, CA
Status: Offline
Points: 5718 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Tom H Quote  Post ReplyReply Direct Link To This Post Posted: 22 May 2019 at 10:48am
Here is a short video that explains the basics, but your only limited by your imagination on how you can use this feature. 
Stay connected - follow us! X - LinkedIn
Back to Top
 Post Reply Post Reply

Forum Jump Forum Permissions View Drop Down



This page was generated in 0.188 seconds.