PCB Libraries Forum Homepage
Forum Home Forum Home > Libraries > Footprints / Land Patterns
  New Posts New Posts RSS Feed - explain the bottom section 3d TH
  FAQ FAQ  Forum Search   Events   Register Register  Login Login

explain the bottom section 3d TH
 Post Reply Post Reply
Author
Message
  Topic Search Topic Search  Topic Options Topic Options
mytime View Drop Down
Active User
Active User


Joined: 06 Dec 2012
Location: Florida
Status: Offline
Points: 19 		Post Options Post Options   Thanks (0) Thanks(0)   Quote mytime Quote  Post ReplyReply Direct Link To This Post Topic: explain the bottom section 3d TH
    Posted: 09 May 2014 at 2:20pm

TH Lead   What is that? the length of the lead


Back to Top
Back to Top
chrisa_pcb View Drop Down
Moderator Group
Moderator Group
Avatar

Joined: 29 Jul 2012
Location: San Diego
Status: Offline
Points: 772 		Post Options Post Options   Thanks (1) Thanks(1)   Quote chrisa_pcb Quote  Post ReplyReply Direct Link To This Post Posted: 09 May 2014 at 2:56pm
TH Lead Length is the length that a through hole lead extends beneath the origin, with a minimum of .1mm so that the model maintains its structure. So if you select 1mm, the leads will extend to -1mm in the vertical axis. Its done this way so that you can specify a board width(which might change), and be able to see the pins of the part poke out the opposite side.
Back to Top
 Post Reply Post Reply

Forum Jump Forum Permissions View Drop Down



This page was generated in 0.250 seconds.