PCB Libraries Forum : Screw Terminals https://www.PCBLibraries.com/forum/ Thu, 09 Apr 2026 21:17:12 +0000 Fri, 31 Aug 2012 04:34:14 +0000 http://blogs.law.harvard.edu/tech/rss Web Wiz Forums 12.07 360 https://www.PCBLibraries.com/forum/RSS_post_feed.asp?TID=523 <![CDATA[PCB Libraries Forum]]> https://www.PCBLibraries.com/forum/forum_images/PCBLForumLogo.gif https://www.PCBLibraries.com/forum/ <![CDATA[Screw Terminals : Cadance Allegro My doubt is...]]> https://www.PCBLibraries.com/forum/screw-terminals_topic523_post1631.html#1631 Author: muthu
Subject: 523
Posted: 31 Aug 2012 at 4:34am

Cadance Allegro
 
My doubt is either wire will be mount on top of the screw or in bettwen of slot side.
 
]]> Fri, 31 Aug 2012 04:34:14 +0000 https://www.PCBLibraries.com/forum/screw-terminals_topic523_post1631.html#1631 <![CDATA[Screw Terminals : Muthu - what CAD software do you...]]> https://www.PCBLibraries.com/forum/screw-terminals_topic523_post1630.html#1630 Author: Mattylad
Subject: 523
Posted: 30 Aug 2012 at 11:48am

Muthu - what CAD software do you use?

As suggested, route and via keepout areas need placing on the component.
This is simple in CADSTAR, what do you use?
]]> Thu, 30 Aug 2012 11:48:39 +0000 https://www.PCBLibraries.com/forum/screw-terminals_topic523_post1630.html#1630 <![CDATA[Screw Terminals : You could probably put vias...]]> https://www.PCBLibraries.com/forum/screw-terminals_topic523_post1628.html#1628 Author: Tom H
Subject: 523
Posted: 30 Aug 2012 at 7:43am

You could probably put vias in the area if you "Tent" them (cover with solder mask).
 
The screw terminal is used for wires and having a no via keepout will prevent the wire from touching any of them (if they are not Tented).
  
]]> Thu, 30 Aug 2012 07:43:56 +0000 https://www.PCBLibraries.com/forum/screw-terminals_topic523_post1628.html#1628 <![CDATA[Screw Terminals : We are using screw terminals...]]> https://www.PCBLibraries.com/forum/screw-terminals_topic523_post1623.html#1623 Author: muthu
Subject: 523
Posted: 30 Aug 2012 at 2:28am

We are using screw terminals on pcb, shown in below image, We have created land pattern asper our  standards. My doubt is  in top of board we  are not given in route or via keepouts . is this ok ? else we need give any keep outs  pls suggest any one? this is the part number (8191 Keystone Electronics)




]]> Thu, 30 Aug 2012 02:28:10 +0000 https://www.PCBLibraries.com/forum/screw-terminals_topic523_post1623.html#1623