FIXED:

• OrCAD PCB/Allegro – Fixed an issue with hidden pins not being filtered
• PADS – Fixed Thermal Pad orientation when chamfered corners were used
• PADS – When ‘Map Alphanumeric pins’ is unchecked, the alphanumeric pins will properly be moved from the Part-Type to the Decal
• PADS – When extended layers is selected and a part type/decal is output, the extended layer selection will now be properly recognized
• PADS – Fixed a problem that was causing through-hole anti-pads generated at half their size
• Ultiboard – Added a &ASC; to the LandPatternName so that they import properly
• Ultiboard – Set the visibility of the pin attribute to ‘2’ to match what had been done in the past
• TARGET 3001! – Pins now properly have pads set to layer 2 instead of layer 100
• Calculator – Header’s switching for millimeter to inch units
• Calculator – Thermal Pad dimensions being swapped