JIS8030 case for SMT inductor
Printed From: PCB Libraries Forum
Category: PCB Footprint Expert
Forum Name: Questions & Answers
Forum Description: issues and technical support
URL: https://www.PCBLibraries.com/forum/forum_posts.asp?TID=562
Printed Date: 25 Nov 2024 at 1:40am
Topic: JIS8030 case for SMT inductor
Posted By: Maarten Verhage
Subject: JIS8030 case for SMT inductor
Date Posted: 17 Sep 2012 at 6:13am
|
Dear FPX developers, I will be using a Taiyo Yuden SMT power inductor on my board. The closest I could get from FPX v2012.18 is the "DFN 2 Pin" package family generator. The catalog of these Taiyo Yuden inductors are found here: http://www.yuden.co.jp/productdata/catalog/en/wound04_e.pdf" rel="nofollow - http://www.yuden.co.jp/productdata/catalog/en/wound04_e.pdf Is the DFN 2 Pin the best generator for these parts? Do you think this needs another generator? What term should I actually use for these "package family generators"? Best regards, Maarten Verhage |
Replies:
Posted By: Tom H
Date Posted: 17 Sep 2012 at 7:54am
I would use the "CHIP" component family "Inductors" and then I would select the "Footprint" tab and enter the Taiyo Yuden SMT power inductor recommended pattern dimensions.  |