Courtyard Interference - Double Sided PCB
Printed From: PCB Libraries Forum
Category: PCB Footprint Expert
Forum Name: Questions & Answers
Forum Description: issues and technical support
URL: https://www.PCBLibraries.com/forum/forum_posts.asp?TID=509
Printed Date: 25 Nov 2024 at 12:22am
Topic: Courtyard Interference - Double Sided PCB
Posted By: plinder
Subject: Courtyard Interference - Double Sided PCB
Date Posted: 24 Aug 2012 at 7:12am
|
In PADs, and I assume other CAD tools as well, the courtyard of all components are on a single layer, regardless of whether the component is on the Top or Bottom of the PCB. When I run the Verify Design tool, clearence violations occur because the courtyards from the Top of the PCB overlap with the courtyards from the Bottom. Is there any way to deal with this, other than turning off the courtyards when running the check?
|
Replies:
Posted By: Tom H
Date Posted: 24 Aug 2012 at 7:53am
|
In PADS, when to flip a part from the Top side to the Bottom side, the Placement Courtyard on Layer_20 (is an "Outline" in the Color Display) gets flipped. I've been using PADS for over 20 years and used courtyards from day 1 and never had a problem with Top and Bottom Courtyards shorting with each other. I can only tell you what the problem is if you send me a piece of your PCB layout. |
Posted By: plinder
Date Posted: 24 Aug 2012 at 8:20am
|
Yes - you are correct - I was mistaken and I am not getting a DRC error for top and bottom courtyard overlaps (even thought he Courtyards appear on the same layer). Is there anyway to "turn-off" one-layer's outlines when placing parts?
Also, I am placing my components on a grid. Some of the placement courtyards "overlap", i.e., they fall right on top of each other. If I remember, the courtyards were intended to do this at minimal spacing. How do I avoid getting DRC errors for this scenario? |
Posted By: Tom H
Date Posted: 24 Aug 2012 at 8:29am
|
Turn Courtyards on/of in Color Display > Layer_20 > Outlines > Top > Bottom If you have a good assembly shop you can touch (bump up) courtyards but not overlap. Just set yout Body to Body Clearance in Setup > Design Rules > Default > Clearance > Body to Body = 0  |
Posted By: plinder
Date Posted: 24 Aug 2012 at 8:52am
|
The Courtyards on/off work as suggested - thanks!
|
Posted By: Tom H
Date Posted: 24 Aug 2012 at 8:58am
|
In the "Verify Design" SETUP there are different options. Body to Body is one and Placement Outline is another. It seems that you have both turned on. Turn Placement Outline off and try it. Turn Body to Body off and try it. |