Library Expert 2019.03 Released!!

Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic

Version 2019.03 was just released!!

UPDATED / FIXED:
Altium:
Fixed an issue where round pads were accidentally getting rotated 10 degrees
Xpedition:
Fixed an issue with multiple paste mask or solder mask, should it include both polys and rectangles. Everything for a layer of a pin, should now be put into one complex pad.
Removed the deprecated “Direct Import” option (as it’s obsolete)
CADSTAR:
Adjusted the Drill Orientation so that it nomalizes to a number between 0 and 360. I.e. -90 will become 270. CADSTAR does not allow for negative rotations on the drill orientation.
The LASUBTYP line will now be excluded from output
Allegro/OrCAD PCB:
Fixed a problem that was causing custom parts with through holes to set the thermal pad to 0 diameter
Fixed a problem that was causing duplication of associated copper that contained arcs
General:
An updated rounding has been added for non-millimeter values across all translators. This should hopefully round numbers that are very close to their actual number properly. Ex: 5.9998 to 6 or 5.1996 to 5.2. Millimeter values don’t have the issue, as they’re the native units.

Author	Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic
Nick B Members Profile Send Private Message Find Members Posts Add to Buddy List Admin Group Joined: 02 Jan 2012 Status: Offline Points: 1909	Post Options Post Reply Quote Nick B Report Post Thanks(0) Quote Reply Topic: Library Expert 2019.03 Released!! Posted: 13 May 2019 at 11:44am
	Version 2019.03 was just released!! UPDATED / FIXED: Altium: Fixed an issue where round pads were accidentally getting rotated 10 degrees Xpedition: Fixed an issue with multiple paste mask or solder mask, should it include both polys and rectangles. Everything for a layer of a pin, should now be put into one complex pad. Removed the deprecated “Direct Import” option (as it’s obsolete) CADSTAR: Adjusted the Drill Orientation so that it nomalizes to a number between 0 and 360. I.e. -90 will become 270. CADSTAR does not allow for negative rotations on the drill orientation. The LASUBTYP line will now be excluded from output Allegro/OrCAD PCB: Fixed a problem that was causing custom parts with through holes to set the thermal pad to 0 diameter Fixed a problem that was causing duplication of associated copper that contained arcs General: An updated rounding has been added for non-millimeter values across all translators. This should hopefully round numbers that are very close to their actual number properly. Ex: 5.9998 to 6 or 5.1996 to 5.2. Millimeter values don’t have the issue, as they’re the native units.
	Stay connected - follow us! X - LinkedIn