|
|
Screw Terminals |
Post Reply 
|
| Author | |
muthu 
Active User 
Joined: 20 Aug 2012 Location: kovai Status: Offline Points: 27 |
 Post Options
 Thanks(0)
 Quote Reply
 Topic: Screw TerminalsPosted: 30 Aug 2012 at 2:28am |
|
We are using screw terminals on pcb, shown in below image, We have created land pattern asper our standards. My doubt is in top of board we are not given in route or via keepouts . is this ok ? else we need give any keep outs pls suggest any one? this is the part number (8191 Keystone Electronics)
 |
|
 |
|
|
|
|
|
|
Tom H
Admin Group 
Joined: 05 Jan 2012 Location: San Diego, CA Status: Offline Points: 5943 |
Post Options
Thanks(0)
Quote Reply
Posted: 30 Aug 2012 at 7:43am |
|
You could probably put vias in the area if you "Tent" them (cover with solder mask).
The screw terminal is used for wires and having a no via keepout will prevent the wire from touching any of them (if they are not Tented). |
|
|
|
|
Mattylad
Advanced User 
Joined: 02 Jun 2012 Location: Lancashire UK Status: Offline Points: 152 |
Post Options
Thanks(0)
Quote Reply
Posted: 30 Aug 2012 at 11:48am |
|
Muthu - what CAD software do you use?
As suggested, route and via keepout areas need placing on the component. This is simple in CADSTAR, what do you use? |
|
|
|
|
muthu
Active User
Joined: 20 Aug 2012 Location: kovai Status: Offline Points: 27 |
Post Options
Thanks(0)
Quote Reply
Posted: 31 Aug 2012 at 4:34am |
|
Cadance Allegro
My doubt is either wire will be mount on top of the screw or in bettwen of slot side. |
|
|
|
|
Post Reply
|
|
| Tweet |
| Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |
Topic Options