|
|
Flex Circuit Footprint |
Post Reply 
|
| Author | |
chads108 
Active User 
Joined: 17 Oct 2012 Location: Plano, TX Status: Offline Points: 35 |
 Post Options
 Thanks(0)
 Quote Reply
 Topic: Flex Circuit FootprintPosted: 20 Aug 2013 at 8:08am |
|
I have a LCD that is to be connected to the PCB via a flex circuit soldered directly to the board. The exposed pads on the flex circuit are 1.6mm x 0.6mm on 1mm pitch. Is there some rule of thumb to use in determining the pad size to be used on the board to attach the flex circuit?
|
|
 |
|
|
|
|
Tom H
Admin Group 
Joined: 05 Jan 2012 Location: San Diego, CA Status: Offline Points: 5718 |
Post Options
Thanks(0)
Quote Reply
Posted: 20 Aug 2013 at 8:33am |
|
I would recommend using the Most environment for the pad size and the Nominal environment for the solder mask size. This is a "Solder Mask" defined pad so that the solder mask helps to hold the pad to the flex board.
The solder mask only has to encroach on the Toe & Heel and not on the sides. If you normally use the Least environment then make the pad size Nominal and the solder mask Least. |
|
|
|
|
Post Reply
|
|
| Tweet |
| Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |
Topic Options