How to update the software

I'm been trying to figure out how to update to a new version of the software without losing my current options.  

If you have updated some the default values, and I want to get those, but do not want to have to enter my user values manually, is there a way to do that?  

Is the update procedure different if it is just an incremental update (e.g. V24.1 to V24.10) then if I am updating from V24 to V25? 

It seems like it would be nice to have a section on upgrading the software in your help area.  Is it there and I'm just not seeing it?

Thank you!

Maybe I'm not doing a good job of describing the situation I am trying to understand.  Let me try again in a more verbose fashion.

For many of the options, I am depending on your default values, for example the values for Toe/Heel/Side for the terminals.  But I need a number of changes from your defaults in other areas (especially drafting options).  When I first started using your software a few years ago, I made those changes and saved my customized ".opt" file.

When I go to update to a new version of the software.  If PCB Libraries has made any updates to (for example) the terminal defaults, I would like to use them. They will be in the newly installed version, but the values I customized in the drafting area are not, of course.  If I "load" my old ".opt" file (which I saved under a different name in the old version), I will get back the customized values I made in the drafting area, but it looks like the new terminal defaults (which I want to use) will be overwritten with the older values in my ".opt" file.

It looks like if I want to use any of your new default values, I will have to reenter the drafting options I want to customize manually.  Is there any way to avoid this?

It sounds like what you are saying is that I really need to keep track of every change I make to the options and manually re-enter them each time I update the software.   Is that what you are saying?  If so, that seems like a strong disincentive to updating.

I'm not sure I understand the "auto-update" feature you described above. I looked at the V24.09 release notes and didn't see that described.  Is that intended to help with the manual re-entry issue I describe above?

A few thoughts I have on this:

1.  Since most of user changes are in the "Drafting" area, you could have a separate option file for that area.  However, drafting changes aren't the only places where users might make subtle changes from the defaults.

2. Another approach which is more involved, but possibly more robust, would be for PCB Expert to keep track of default changes it has made over the years.  When a user reads in his custom ".opt" file, if PCB Expert sees a value which is still set at an old default, it asks the user if they would like to update to the new default value.