Print Page | Close Window

How Do I Make An Edge Connector?

Printed From: PCB Libraries Forum
Category: PCB Footprint Expert
Forum Name: Questions & Answers
Forum Description: issues and technical support
URL: https://www.PCBLibraries.com/forum/forum_posts.asp?TID=1238
Printed Date: 19 Nov 2024 at 12:28am


Topic: How Do I Make An Edge Connector?
Posted By: DickMS
Subject: How Do I Make An Edge Connector?
Date Posted: 19 Jan 2014 at 11:14pm
Could do it easily, I bet, if I knew how to make a pad that was only on the bottom, but that's another thing I can't figure out.

Any help on this, Tom?

Thanks,
DickMS


Replies:
Posted By: Tom H
Date Posted: 21 Jan 2014 at 7:46am

We missed rolling this out in the V2013 release.

We'll have to add this feature in V2014.

I need to discuss this simple issue with the programmers.




-------------
Stay connected - follow us! https://twitter.com/PCBLibraries" rel="nofollow - X - http://www.linkedin.com/company/pcb-libraries-inc-/" rel="nofollow - LinkedIn

Posted By: DickMS
Date Posted: 21 Jan 2014 at 10:25am
Sounds good... BTW, you might want to get them to figure out a way to make the footprints you create be editable in the OrCAD PCB Editor, since that would make a lot of final cleanup really much easier... For instance, the paste masks that PLX made for my IRFH4253 were considerably different from the manufacturer's recommendation, and I had to edit the scripts to get them made correctly. Editting the scripts also made the notched pad that PLX couldn't create out of the chamfered one it could. I've attached a picture of the final result - even when PLX can't do something, it's useful to get close, and hand edit from there!


Thanks again, for all your help!

Oh, and one final question: When I copy a footprint from one fpx library to another, it loses almost all of the ancillary data - like manufacturer, part number, description, etc.... Is this by design? It would be great not to have to re-enter everything.

Posted By: DickMS
Date Posted: 21 Jan 2014 at 10:31am
Sorry - forgot the image:

IRFH4253      http://i.imgur.com/MPIam6a.png" rel="nofollow - http://i.imgur.com/MPIam6a.png

Posted By: Tom H
Date Posted: 23 Jan 2014 at 9:25am
We decided to roll this new feature out in V2013.19 FP Designer.
 
If you need it right now we can get you a V2013.19 pre-release.
 


-------------
Stay connected - follow us! https://twitter.com/PCBLibraries" rel="nofollow - X - http://www.linkedin.com/company/pcb-libraries-inc-/" rel="nofollow - LinkedIn

Posted By: DickMS
Date Posted: 23 Jan 2014 at 2:56pm
Thanks, Tom - as always, your customer service is exceptional. I think I will wait for the .19 release, so as not to put unnecessary extra work on your team. I'm in a 2 week lull between board designs, so it can wait, as far as my needs go. Thanks, in any case!

--Dick


Print Page | Close Window