|
|
Through-hole Solder & Paste Mask Pad Stack Issue |
Post Reply 
|
Page <12 |
| Author | |
Tom H 
Admin Group 
Joined: 05 Jan 2012 Location: San Diego, CA Status: Offline Points: 5940 |
 Post Options
 Thanks(0)
 Quote Reply
 Posted: 1 hour 50 minutes ago at 8:35am |
|
Solder Mask Expansion is set in Altium Preferences.
In Altium go to 'Preferences > PCB Editor > Defaults > Pad > SOLDER Expansion > 0.00' Then the solder mask expansion will be 1:1 scale.  |
|
 |
|
|
|
|
|
|
Post Reply
|
Page <12 |
| Tweet |
| Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |
Topic Options