![]() |
![]() |
explain the bottom section 3d TH |
Post Reply ![]() |
Author | |
mytime ![]() Active User ![]() Joined: 06 Dec 2012 Location: Florida Status: Offline Points: 19 |
![]() ![]() ![]() ![]() ![]() Posted: 09 May 2014 at 2:20pm |
TH Lead What is that? the length of the lead |
|
![]() |
|
![]() |
|
chrisa_pcb ![]() Moderator Group ![]() ![]() Joined: 29 Jul 2012 Location: San Diego Status: Offline Points: 772 |
![]() ![]() ![]() ![]() ![]() |
TH Lead Length is the length that a through hole lead extends beneath the origin, with a minimum of .1mm so that the model maintains its structure. So if you select 1mm, the leads will extend to -1mm in the vertical axis. Its done this way so that you can specify a board width(which might change), and be able to see the pins of the part poke out the opposite side.
|
|
![]() |
Post Reply ![]() |
|
Tweet |
Forum Jump | Forum Permissions ![]() You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |