PCB Libraries Forum Homepage
Forum Home Forum Home > Training / Events > PCB Design Basics
  New Posts New Posts RSS Feed - FR4
  FAQ FAQ  Forum Search   Events   Register Register  Login Login

FR4

 Post Reply Post Reply
Author
Message
silverlombard View Drop Down
New User
New User


Joined: 03 Oct 2017
Status: Offline
Points: 2
Post Options Post Options   Thanks (0) Thanks(0)   Quote silverlombard Quote  Post ReplyReply Direct Link To This Post Topic: FR4
    Posted: 03 Oct 2017 at 8:02pm
The base material, or substrate, is usually fiberglass. Historically, the most common designator for this fiberglass is “FR4”. This solid core gives the PCB its rigidity and thickness. There are also flexible PCB's built on flexible high-temperature plastic (Kapton or the equivalent).

You will find many different thickness PCB's; the most common thickness for SparkFun products is 1.60 mm (0.063"). Some of our products: LilyPad boards and Arudino Pro Micro boards use a 0.80 mm thick board.

Perf board

Cheaper PCB's and perf boards (shown above) will be made with other materials such as epoxies or phenolics which lack the durability of FR4 but are much less expensive. You will know you are working with this type of PCB when you solder to it - they have a very distictive bad smell. 

These types of substrates are also typically found in low-end consumer electronics. Phenolics have a low thermal decomposition temperature which causes them to delaminate, smoke and char when the soldering iron is held too long on the board.


Back to Top
Back to Top
 Post Reply Post Reply

Forum Jump Forum Permissions View Drop Down



This page was generated in 0.203 seconds.