PCB Libraries Forum Homepage
Forum Home Forum Home > Libraries > Footprints / Land Patterns > OrCAD PCB
  New Posts New Posts RSS Feed - Multiple text lines on single subclass issue
  FAQ FAQ  Forum Search   Events   Register Register  Login Login

Multiple text lines on single subclass issue

 Post Reply Post Reply
Author
Message
rrix View Drop Down
Active User
Active User


Joined: 10 Jan 2018
Status: Offline
Points: 34
Post Options Post Options   Thanks (0) Thanks(0)   Quote rrix Quote  Post ReplyReply Direct Link To This Post Topic: Multiple text lines on single subclass issue
    Posted: 07 Feb 2022 at 3:53pm
When I create a footprint from Footprint Expert, it generates the *.dra file okay, but fails when trying to generate the *.psm file.  Here's the error:


Create symbol started.

 
 WARNING(SPMHA1-299): Create symbol multiple text lines are not supported on a single component type subclass. 
    Item=1, Text= 'Dev' Layer= DEVICE TYPE/ASSEMBLY_TOP Location= (0.0000 0.0000)
    Item=2, Text= 'Ref' Layer= DEVICE TYPE/ASSEMBLY_TOP Location= (0.0000 0.0000)

 WARNING(SPMHA1-299): Create symbol multiple text lines are not supported on a single component type subclass. 

ERROR(SPMHA1-291): Create symbol has been aborted.

Is there an option to either turn off creation of one or both of these two text lines; or to change the subclass they go to?

Back to Top
Back to Top
 Post Reply Post Reply

Forum Jump Forum Permissions View Drop Down



This page was generated in 0.141 seconds.