PCB Libraries Forum Homepage
Forum Home Forum Home > Libraries > Schematic Symbols > OrCAD Capture
  New Posts New Posts RSS Feed - IPC naming convention for schematic symbols?
  FAQ FAQ  Forum Search   Events   Register Register  Login Login

IPC naming convention for schematic symbols?

 Post Reply Post Reply Page  <12
Author
Message
Randy Clemmons View Drop Down
Advanced User
Advanced User
Avatar

Joined: 02 May 2012
Location: San Diego
Status: Offline
Points: 104
Post Options Post Options   Thanks (0) Thanks(0)   Quote Randy Clemmons Quote  Post ReplyReply Direct Link To This Post Posted: 21 Jun 2012 at 8:24pm
Back to Top
Back to Top
JohnH View Drop Down
New User
New User
Avatar

Joined: 24 Jun 2013
Location: UK
Status: Offline
Points: 1
Post Options Post Options   Thanks (0) Thanks(0)   Quote JohnH Quote  Post ReplyReply Direct Link To This Post Posted: 24 Jun 2013 at 12:45am
As mentioned it very much depends on the system.
 
In general I prefer systems which can support the "one to many" approach where a symbol can map to multiple footprints. These systems are typically supported by a database.
 
For symbols which incorporate the pin number mapping I use this convention:
 
[Prefix]_[item]_[Variant]
 
For an IC the prefix would be IC and the item would be the manufacturers part number with RoHS and packaging codes removed.
 
For other parts such as Transistors the prefix would be Transistor the item could be NPN and the variant would be the pin mapping in the order of pin e.g.
 
Transistor_NPN_ebc
 
This is an NPN transistor with emitter pin 1, base pin 2 and collector pin 3
Back to Top
 Post Reply Post Reply Page  <12

Forum Jump Forum Permissions View Drop Down



This page was generated in 0.203 seconds.