Footprint Expert 2021.10 Released!!

Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic

2021.10 was just released!!

Updates & Bugs Fixed:
Calculator Component Families:
BGA – when changing the paste mask reduction, the calculator produced the incorrect result.
Quad and Grid Array packages – when entering the D & E pin qty the total was an inaccurate value until the Calculate button was selected.
SON – using the mfr. recommended pattern was causing pads to react differently under certain dimensions.
SOD – moving the Calculator SOD to FP Designer caused several missing cell data information.
All component families with Thermal Tabs – Tabs on Assembly produced 2 outlines.
All SMD component families – if the mfr. recommended pattern is being used it should remove the Density Level from the footprint name.
All PTH component families – there is only one Density Level for through-hole footprints and the footprint name should not indicate “Nominal Density” 

Author	Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic
Nick B Members Profile Send Private Message Find Members Posts Add to Buddy List Admin Group Joined: 02 Jan 2012 Status: Offline Points: 1904	Post Options Post Reply Quote Nick B Report Post Thanks(0) Quote Reply Topic: Footprint Expert 2021.10 Released!! Posted: 11 Jul 2021 at 10:02pm
	2021.10 was just released!! Updates & Bugs Fixed: Calculator Component Families: BGA – when changing the paste mask reduction, the calculator produced the incorrect result. Quad and Grid Array packages – when entering the D & E pin qty the total was an inaccurate value until the Calculate button was selected. SON – using the mfr. recommended pattern was causing pads to react differently under certain dimensions. SOD – moving the Calculator SOD to FP Designer caused several missing cell data information. All component families with Thermal Tabs – Tabs on Assembly produced 2 outlines. All SMD component families – if the mfr. recommended pattern is being used it should remove the Density Level from the footprint name. All PTH component families – there is only one Density Level for through-hole footprints and the footprint name should not indicate “Nominal Density”
	Stay connected - follow us! X - LinkedIn