Mounting Hole Gap?

Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic

   For a non-plated mounting hole with vias, how do I change the gap between the annular ring and the non-plated drill? 
Is there a setting to make the gap wider?

Thanks

Author	Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic
dannicholson Members Profile Send Private Message Find Members Posts Add to Buddy List Active User Joined: 13 May 2014 Status: Offline Points: 15	Post Options Post Reply Quote dannicholson Report Post Thanks(0) Quote Reply Topic: Mounting Hole Gap? Posted: 21 Oct 2014 at 5:20am
	For a non-plated mounting hole with vias, how do I change the gap between the annular ring and the non-plated drill? Is there a setting to make the gap wider? Thanks



Jeff.M Members Profile Send Private Message Find Members Posts Add to Buddy List Admin Group Joined: 16 May 2012 Location: San Diego Status: Offline Points: 477	Post Options Post Reply Quote Jeff.M Report Post Thanks(0) Quote Reply Posted: 21 Oct 2014 at 12:44pm
	I'm assuming you mean for the anti-pad? If you're using the 'proportional' fabrication level there is no available adjustment. In the 'User' Fab level you can set all aspects of the pad stack. This will change in the next software version where 'proportional will be the only method for both user and default but all controlling values will be available.
	Stay connected - follow us! Twitter - LinkedIn