Version 2013.15 was just released!!

• Through-hole Mounting Holes for plated/non-plated holes with round & slotted shapes, satellite vias and Donut pad shape option
• Through-hole Calculators – Added ability to define custom (mfr. recommended) through-hole padstack
• Through-hole Crystal component family w/3D model
• 3D STEP – Relocate Pin 1 polarity marker depending if pin 1 is on side or center of QFP, QFN, PQFN
• 3D STEP – Added new GUI to allow the user to change the Color of the component Body, Polarity and Lead
• 3D STEP – Quality and TH Lead Length are now accessible from the STEP-only translator
  

FIXED / ENHANCED:

• 2-Pin DFN – Pin pitch
• Fixed an issue with Radial parts that was causing the leads to be the wrong height
• Oscillator, Corner Concave 3D Model is properly seated on its leads again
• Oscillator, Plated Through-hole 3D Model the leads not to display properly at a TH Lead Length of 0
• Header, Right Angle Post 3D Model that was causing it not to display properly
• FP Designer – Updated the GUI with improvements for ease of use
• Expedition – Paste Mask should now be properly hooked to ASCII padstacks
• Expedition – Fixed an issue that was preventing the stencil pads from being offset properly. 
• Expedition – Pads with a length by width will no longer have spaces around the 'x'.
• 3D STEP – Header Vertical, both Round and Square holes, had graphical issues
• 3D STEP – Quality and TH Lead Length are now accessible from the STEP-only translator
• 3D STEP – Non-Symmetric Left-Oriented parts (SOT223, SOT23, etc.), when built in a custom orientation, would not put out a proper 3D model
• Anytime a footprint name is used in a filename or directory, a slash "/" will now be replaced with a dash "–"
• Freestanding Arcs from FPX "Footprint Designer" now translate properly